Crear actividad
Crear actividad
Todas las actividades
Jugar Test
1. 
This L section of Duct has what thickness of JM Fiberglass Duct Liner?
A.
2"
B.
1"
2. 
The Green shaded area is:
A.
TDF Flange
B.
Ductmate Flange
C.
Galvanized Angle
3. 
What's on the edge where the Red line is marked?
A.
Right Angle Flange/Male Pitts
B.
Drive Turn
C.
Female Pittsburgh Seam
4. 
What's the yellow outline called?
A.
Female Pittsburgh Seam
B.
Flat S Lock
C.
Drive and S Connection
5. 
If the duct dimension is 20" x 18", what is the cut of the liner that's running horizontally along the Blue dotted line?
A.
20"
B.
18"
C.
22"
6. 
What is the cut of the Liner running Vertically along the Blue dotted line?
A.
15"
B.
18"
C.
20"
7. 
What piece of liner in the photo is cut and applied first?
A.
Blue Horizontal dotted line
B.
Blue Vertical Dotted Line
8. 
The reason a shop would cut two pieces and apply after the L section is turned in Brake would be all of the below except what?
A.
They don't have a liner sizer
B.
They save on liner by using 2 pieces
C.
They don't lose R value at bend point
D.
It's cleaner and better looking than bending after liner is applied
9. 
The Orange gap (shaded) is because:
A.
The other L section will look just like this and join neatly into that orange gap
B.
The shop used 56 Liner
C.
Shop prefers a gap of unlined
10. 
The adhesive has been applied to the liner and metal.
A.
Yes
B.
No
11. 
The next step for this product is:
A.
Weld pins
B.
Joining this with another section